ProBike Motorcycle Workshop Equipment

MoT Equipment

Roller Brake Tester
Specifically designed motorcycle MOT Roller Brake Tester.
RBT
£6,250.00 + VAT

The DE9015 series Roller Brake Tester has been specifically designed in conjunction with the Motor Cycle Industry for the testing of solo and combination
motorcycles.

The compact unit comprises a flush fitting roller bed with cover plate and a wall or pedestal mounted display console providing clear and accurate test results. The rollers are resin bonded for long life, and grit covered for maximum adhesion under all test conditions.

BENEFITS:
* Automatic operation as rollers stop at wheel slip, with gauge pointer locking so indicating maximum brake force achieved.
* Remote controlled operation as standard.
* Accurate test procedure supported by optional printed test report sheet.
* Suitable for use as standalone diagnostic unit.
* Increased efficiency with simple, fast and accurate one-man operation.
* D.Tp. accepted, as required by UK legislation, for the statutory testing of motorcycles and combinations (Class I and II).
* Diagnostic display for brake faults like oval drums, warped & cracked disks etc.
* No requirement for a high friction floor surface.
* Integral weighing of axle weight & automatic brake efficiency calculation.

FEATURES:
MOT approved by the Vehicle Inspectorate
Bi-directional operation
Flush fitting roller set allows compact bay layouts
Full infra-red remote control
Easy to use with automatic calculations during test
Highly accurate for consistent, reliable results
Printer port & RS232 port as standard
Integral automatic 4 point weighing system
Analogue & digital display of brake force
Digital display of maximum brake force, bike weight and calculated brake efficiency percentage
Built-in one button mode for sidecar testing
Includes tests for linked brake systems
Check for warped disks / oval drums
Automatic zero calibration point
Wheel slip roller stop
Epoxy coated rollers
Motor protection against ingress of water
Easy drive out mode
Low speed rollers to avoid 'kick out'
Manual emergency stop button built in on display.
Delivery, installation (in prepared site), commissioning, certification & on-site training is included in the price.

TECHNICAL SPEC:
Roller bed unit size - LWH: 80cm 62cm 31cm
Roller length 300mm
Roller distance between centres 400mm
Roller diameter 206mm
Weight 80Kg
Co-efficient of friction dry/wet 0.9/0.6
Slip roller diameter 80mm
Brake force measurement range 300 Kg
Motor power 2.2Kw
220/240 volt 50Hz Single Phase 25Amp
Test speed 2.9Km/h
Maximum axle load 750Kg
4 cell weighing system
Power/Signal Cable length 8m (longer on request)
Temperature working range 0-60°C

E-Mail: Sales@ProBike.co.uk